CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 578)

560
„ LED Panel always stays on top: This option makes the LED panel stay on top of other
windows when the Media Man Tools window is minimized.
„ Synchronize the LED Panel with the LED Device on GV-Hot Swap DVR: This option is
designed for the use of the GV-Hot Swap DVR System. When this option is enabled, the
LED device installed on the front panel of the GV-Hot Swap DVR System will synchronize
with the LED panel on the screen.
„ Enable disk full beep: When the hard disk drive is full, the system sounds on. Note this
function only works when the motherboard is equipped or installed with a PC speaker.
2. By default, only the hard disk drive that stores video and audio files will be assigned to LED. If you
want to re-assign the hard disk drive or assign other drives to LEDs, freely move the hard disk
drive to the desired LED on the tree.
3. Click OK to apply the settings, and minimize the Media Man Tool window to display the LED panel
on the screen.
4. If you want to return to the Media Man Tools window, right-click the LED panel and select Switch
to the setup window.
Note:
1. Because the LEDs are designed to indicate the video and audio files are being written or read, it
is not recommended to assign the HDDs that store log files to the LEDs.
2. If the HDD that stores log files is assigned to a LED and its LED turns red, make sure the log
files are not being written before you remove it. Otherwise, the log files might be lost during the
removal. For details on storage locations of logs and video/audio files, see Setting Data Storage
in Chapter 1.