Teledyne 6200E - Sulfides Analyzer - Manual (Page 98)

Operating Instructions Model 6200E Instruction Manual
98 M6200E Rev: A1
6.9.8. Pressure Calibration
A sensor at the exit of the sample chamber continuously measures the pressure of the sample gas.
This data is used to compensate the final H
2
S concentration calculation for changes in atmospheric
pressure when the instrument’s TPC feature (see Section 10.7.3) is turned on and is stored in the
CPU’s memory as the test function PRES (also viewable via the front panel).
To cause the analyzer to measure and record a value for PRES, press.
Exit at
any time
to return
to main
the
SETUP
menu
DIAG SIGNAL I / O
NEXT ENTR EXIT
Repeat Pressing NEXT until . . .
DIAG PRESSURE CALIBRATION
PREV NEXT ENTR EXIT
DIAG FCAL LAMP CAL VALUE:27.20 IN-HG-A
2 7 .2 0 ENTR EXIT
ENTR accepts the
new value
EXIT ignores the new
value
The value displayed is the
current output of the UV
source reference detector
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SAMPLE RANGE = 500.0 PPB H2S =XXX.X
< TST TST > CAL SETUP
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT