Teledyne 6200E - Sulfides Analyzer - Manual (Page 281)

Model 6200E Instruction Manual APPENDIX A-1: M6200E Software Menu Trees, Revision A.1
M6200 Rev A.1 281
.
YES NO
SAMPLE FLOW WARNING
BENCH TEMP WARNING
SOURCE WARNING
BOX TEMP WARNING
WHEEL TEMP WARNING
SAMPLE TEMP WARNING
SAMPLE PRESSURE WARNING
INVALID CONC
INSTRUMENT OFF
IN MANUAL CALIBRATION MODE
IN ZERO CALIBRATION MODE
IN SPAN CALIBRATION MODE
UGM
MGM
PPB
PPM
TYPE 1
TYPE 2
CFG
ACAL 1
SETUP
CLK PASS RNGE DAS MORE
COMM VARS
See
Fig A-8
1 Only appears if a valve is installed.
2 Only appears when the HESSEN mode is enabled for
either COM1 or COM2.
COM1 COM2
See Table 6-27 for
Flag Assignments
See
Fig A-5
ID HESN 2
RESPONSE MODE GAS LIST STATUS FLAGS VARIATION
EDIT
BCC TEXT CMD
DEL EDIT PRNT INS PREV NEXT
SO2, 111, REPORTED
DIAG
ENTER SETUP PASS: 818
See
Fig A-5
H@S, 112, REPORTED
GAS TYPE
GAS ID
REPORTED
Select from list of
available gases
(see Section 6.12.4.6).
ON
OFF
Set Hessen ID number for
selected gas type
(see Section 6.12.4.6).
Figure A-7: Secondary Setup Menu - HESSEN Submenu