Teledyne 6200E - Sulfides Analyzer - Manual (Page 80)

Operating Instructions Model 6200E Instruction Manual
80 M6200E Rev: A1
6.8.1. Setting the Gas Measurement Mode
If the M6200E is equipped with the appropriate SO
2
switching valves and software, several gas
measurement modes are available. The instrument can be set to measure H
2
S, SO
2
, or cycle
between both gases (see Section 10.3.2). To select one of these three measurement modes,
press:
SETUP X.X 0 ) MEASURE_MODE=H2S
NEXT JUMP EDIT PRNT EXIT
EXIT ignores the new
setting.
ENTR accepts the
new setting.
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SAMPLE RANGE = 500.0 PPB H2S =XXX.X
< TST TST > CAL SETUP
SETUP X.X MEASURE MODE: H2S
PREV ENTR EXIT
SETUP X.X MEASURE MODE: H2S-SO2
PREV NEXT ENTR EXIT
SETUP X.X MEASURE MODE: SD2
NEXT ENTR EXIT
H2S mode is the
default mode for the
M101E
Press the PREV
and NEXT buttons
to move back and
forth between gas
modes