Teledyne 6200E - Sulfides Analyzer - Manual (Page 22)

Getting Started Model 6200E Instruction Manual
22 M6200E Rev: A1
6. Verify that all of the optional hardware ordered with the unit has been installed. These are
checked on the paperwork (Form 04551) accompanying the analyzer.
7. Once you have determined that no shipping damage exists and the unit includes all expected
hardware options, remove five, RED colored shipping screws from the bottom of the chassis,
shown in Figure 3-1. There are:
• Three locking down the sample chamber sensor housing assembly.,
• Two locking down the internal pump visible from bottom of instrument).
Sensor Housing Shipping Screws
Remove from inside of instrument.
Pump Shipping Screws
Remove from outside, bottom of instrument.
Figure 3-1: Location of Shipping Screws
NOTE
Save these shipping screws and re-install them whenever the unit is shipped.