Teledyne 6200E - Sulfides Analyzer - Manual (Page 244)

TROUBLESHOOTING & REPAIR Model 6200E Instruction Manual
244 M6200E Rev: A1
output while in the diagnostic signal I/O menu. This is because manually changing I/O outputs
can invalidate the instrument reading.
Toggles parameter
ON/OFF
Exit returns to
DIAG display & all values
return to software control
DIAG SIGNAL I/O
PREV NEXT ENTR EXIT
DIAG I/O 0 ) EXT_ZERO_CAL=ON
PREV NEXT JUMP PRNT EXIT
DIAG I/O 23 ) ST H2S_MODE= ON
PREV NEXT JUMP ON PRNT EXIT
DIAG I/O 37) SAMPLE_PRESSURE=6000.0 MV
PREV NEXT JUMP PRNT EXIT
DIAG I/O 23 ) ST H2S_MODE OFF
PREV NEXT JUMP OFF PRNT EXIT
If parameter is an
input signal
If parameter is an output
signal or control
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE RANGE = 500.0 PPB H2S =XXX.X
< TST TST > CAL SETUP
Figure 11-2: Example of Signal I/O Function
11.1.4. Status LEDs
Several color-coded, light-emitting diodes (LEDs) are located inside the instrument to determine if
the analyzer’s CPU, I
2 C communications bus and relay board are functioning properly.
11.1.4.1. Motherboard Status Indicator (Watchdog)
DS5, a red LED on the upper portion of the motherboard, just to the right of the CPU board,
flashes when the CPU is running the main program. After power-up, DS5 should flash on and off