Teledyne 6200E - Sulfides Analyzer - Manual (Page 35)

Model 6200E Instruction Manual Getting Started
M6200E Rev: A1 35
Table 3-7: Possible Warning Messages at Start-Up
MESSAGE MEANING
ANALOG CAL WARNING The instruments A/D circuitry or one of its analog outputs is not
calibrated.
AZERO WRN XXX.X MV The reading taken during the auto-zero cycle is outside of specified limits.
The value XXX.X indicates the auto-zero reading at the time of the
warning.
BOX TEMP WARNING The temperature inside the M6200E chassis is outside the specified limits.
CANNOT DYN SPAN Remote span calibration failed while the dynamic span feature was set to
active
CANNOT DYN ZERO Remote zero calibration failed while the dynamic zero feature was set to
active
CONFIG INITIALIZED Configuration was reset to factory defaults or was erased.
DARK CAL WARNING Dark offset above limit specified indicating that too much stray light is
present in the sample chamber.
DATA INITIALIZED iDAS data storage was erased.
FRONT PANEL WARN Firmware is unable to communicate with the front panel.
HVPS WARNING High voltage power supply for the PMT is outside of specified limits.
IZS TEMP WARNING On units with IZS options installed: The permeation tube temperature is
outside of specified limits.
PMT DET WARNING PMT detector output outside of operational limits.
PMT TEMP WARNING PMT temperature is outside of specified limits.
RCELL PRESS WARN Sample chamber pressure is outside of specified limits.
RCELL TEMP WARNING Sample chamber temperature is outside of specified limits.
REAR BOARD NOT DET The CPU is unable to communicate with the motherboard.
RELAY BOARD WARN The firmware is unable to communicate with the relay board.
SAMPLE FLOW WARN The flow rate of the sample gas is outside the specified limits.
SAMPLE PRESS WARN Sample pressure outside of operational parameters.
SYSTEM RESET The computer was rebooted.
UV LAMP WARNING The UV lamp intensity measured by the reference detector reading too
low or too high
To view and clear warning messages:
SAMPLE HVPS WARNING SO2 = 0.00
TEST CAL MSG CLR SETUP
Make sure warning messages are
not due to real problems.
Press CLR to clear the current
message.
If more than one warning is active, the
next message will take its place
Once the last warning has been
cleared, the analyzer returns to
SAMPLE mode
SAMPLE RANGE=500.000 PPB SO2 = 0.00
< TST TST > CAL
MSG CLR SETUP
SAMPLE SYSTEM RESET SO2 = 0.00
TEST CAL
MSG CLR SETUP
TEST deactivates warning
messages
MSG activates warning
messages.
> keys replaced with
TEST key
NOTE:
If the warning message persists
after several attempts to clear it,
the message may indicate a
real problem and not an artifact
of the warm-up period