Paradyne 6800 - Manual (Page 83)

COMSPHERE 6800 Series Network Management System
3-2 January 1997 6800-A2-GN22-30
Fujitsu DL5600
The Fujitsu DL5600 is a multicolor dot matrix printer. To modify its default settings, you use the
buttons on the front control panel. This panel is shown in Figure 3-1.
The following procedure explains how to use the front control panel to modify the settings:
1. Remove the printer from its carton, connect the power cable to the printer, plug the power
cable into an outlet, and turn the printer’s power on. (For detailed instructions, consult the
Fujitsu DL5600 Dot Matrix Printer User’s Manual that comes with the machine.)
2. Once the printer has been powered on, you can modify its settings. To do this, you must
first put the printer in SETUP mode. Press the RESET and ONLINE buttons at the same
time. The message
SETUP MODE
will appear in the display area of the front control panel. This message is then replaced by
the message
FUNCTN:SEL.MENU
3. SETUP mode consists of a number of functions. The first function is referred to as
MENU1. To access this function, press the FF button. The message
MENU1
will appear in the display area. The MENU1 function consists of 22 individual printer
settings. These settings are shown below along with the correct value for each setting
(these values are correct for both serial and parallel connections to the host processor).
Figure 3-1. DL5600 — Front Control Panel