Paradyne 6800 - Manual (Page 248)

Loading and Restoring Software
5-87 6800-A2-GN22-30 January 1997
Installing MS-DOS
A full-feature workstation requires the MS-DOS
r operating system, which comes with the
workstation software. The workstation software is initially loaded at the manufacturer. You may
have to reload this software because of hard disk failure or system upgrade. When reloading, it is
advisable to reformat the hard disk before installing the software.
To reformat, create a bootable disk by using the format /s command. Then copy the format
command (found on the MS-DOS Operating system disk) onto the bootable disk. Boot the system
from the bootable disk and execute the format command on the hard disk.
Once the hard disk has been re-formatted, remove the rebootable disk and locate the two MS-DOS
disks labeled Install and Operating System.
Use the following procedures to install MS-DOS.
1. Insert the disk labeled 1 of 2 into Drive A and turn on the power to the computer.
2. The Welcome screen appears.
PRESS: Enter
3. The screen displays the default settings for Date/Time, Country, Keyboard and Install to
Hard Disk. Change the defaults, if necessary.
PRESS: Enter
4. The screen displays two setup options (Install to C:\/DOS and Run Shell on start up – Yes).
Change the second option so that the shell will not run at start-up. Follow the instructions
displayed on the screen.
PRESS: Enter
5. A new screen displays a graph indicating the percentage of information transferred from
the floppy disk to the hard disk.
When prompted remove Disk 1 and insert Disk 2.
PRESS: Enter
6. When prompted, remove Disk 2.
PRESS: Enter
The system reboots; MS-DOS 5.0 is installed and running.