Paradyne 5216 - Manual

TM
1
Hotwire
r
5216 RTU Customer Premises
Installation Instructions
Document Number 5216-A2-GN10-20
June 1999
Before You Begin
The Hotwire
r
5216 RTU (Remote Termination Unit) interoperates with the Hotwire 8540
DSL Card in the DSLAM (Digital Subscriber Line Access Multiplexer) system.
An optional POTS (Plain Old Telephone Service) splitter is available for the Hotwire
5216 RTU. When a POTS splitter is installed, the telephone and 5216 RADSL (Rate
Adaptive Digital Subscriber Line) RTU can function at the same time over the same pair
of copper wires. In order to confirm the RTU installation, the POTS splitter should be
installed first.
To install a POTS splitter, refer to the appropriate POTS splitter document:
Document Number Document Title
5030-A2-GN10 Hotwire 5030 POTS Splitter Customer Premises
Installation Instructions
5038-A2-GN10 Hotwire 5038 Distributed POTS Splitter Customer
Premises Installation Instructions
Contact your sales or service representative to order additional product documentation.
Paradyne documents are available on the World Wide Web at www.paradyne.com.
Select
Library
→
Technical Manuals.
Wiring and Cables Needed
The following wiring and standard connectors are used with this product:
-
New or existing unshielded twisted-pair wiring (CAT3 or better). The CAT3 wiring
must meet EIA/TIA-568 specifications with 24 AWG (.5 mm) or 26 AWG (.4 mm).
-
Standard RJ11 wall jack.
-
Standard Ethernet crossover cable with an 8-pin, non-keyed modular plug for a PC
or workstation. Refer to
Installing the Hotwire 5216 RTU, page 8, for Ethernet
cable details.