Paradyne 6800 - Manual (Page 145)

Connecting the Components
4-41 6800-A2-GN22-30 January 1997
•
Two DCE devices with the following characteristics:
— Asynchronous
— Full-duplex
— Flow control ON
— Bit rates of 1200, 2400, 4800, 9600, 19,000 bps (the 19,000 bps rate requires the
presence of a soft channel card [SC-1])
•
835-5783-0011 cable
To establish the connection, perform the following steps at the processor end:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor or UIP.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the local DCE.
Perform the following steps at the remote end:
1. Connect one end of the 835-5783-0011 cable to the remote DCE.
2. Connect the other end of the 835-5783-0011 cable to the MIU attached to the DCX
multiplexer.
See Appendix A, Modem Settings, for more information on optioning 3810, 3811, 3820, or
2224CEO modems for this application.
Connecting a Computer System Requiring VT100 Emulation
The purpose of VT100 terminal emulation is to allow a workstation connected to the host
processor or UIP to emulate the standard Digital Equipment Corporation (DEC) VT-100
t
terminal via a cut-through interface.
Connecting Locally
Since this connection depends on the device you are connecting to, you will need the following
materials:
•
035-0153-0031 cable
•
002-0040-0031 connector
•
002-0052-0031 connector
To establish the connection, perform the following steps:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor or UIP.