Opening the system 5000 host – Paradyne 6800 User Manual

Page 28

Preparing the Processors

2-5

6800-A2-GN22-30

January 1997

Opening the System 5000 Host

To open the Altos System 5000 and install the memory and circuit cards, you will need a # 2
Phillips screwdriver and a .25

I nut driver. Once you have these tools, perform the following steps:

CAUTION

1. Make sure the ac power cord is not connected to the System
5000 before opening the computer and attempting to perform
any field installation activity.
2. To prevent static discharges that may damage the hardware,
wear a ground strap or otherwise ground yourself to the
chassis before opening the computer and installing any circuit
cards.

1. Using the # 2 Phillips screwdriver, loosen the two screw-type fasteners (locking pins) that

secure the cover to the chassis. The fasteners are located on the rear panel near the right
side edge, as shown in Figure 2-1.

491-13841

Screw-type

Locking Pins

Figure 2-1. System 5000 — Cover Fasteners