Paradyne 6800 - Manual (Page 224)

Loading and Restoring Software
5-63 6800-A2-GN22-30 January 1997
7. After some time marked by a line of dots on the screen, the system prompts:
Insert the X-ONE disk Labeled ‘Fonts Disk 2’
Press ENTER to continue or ‘q’ to Quit
Remove Fonts Disk 1, insert requested disk, and
PRESS: Enter
8. After another period also marked by the line of dots on the screen, the following messages
appear:
All files successfully installed
The following should be placed in your autoexec.bat file
SET XONEDIR=C:\/XONE
SET DOS4G=quiet
Would you like X-One to add this to your autoexec.bat file (y/n)? [y]:
PRESS: Enter
9. The system prompts:
Ready to execute setup
Press any key to continue
PRESS: Enter
10. The system prompts:
X-One Setup Utility
Press any key to continue
PRESS: Enter
11. The system prompts:
Select Mouse type
1. Mouse type device (pre-loaded driver)
2. Microsoft serial mouse
3. Logitech serial mouse
4. Mouse Systems serial mouse
Enter selection or ‘q’ to Quit [1]:
TYPE: 1
PRESS: Enter
12. The system prompts:
Would you like to use the graphics board configuration detected by
Xsetup (y/n)? [y]:
PRESS: Enter