Paradyne 6800 - Manual (Page 175)

COMSPHERE 6800 Series Network Management System
5-14 January 1997 6800-A2-GN22-30
Before you continue you should make sure that your boards are
correctly configured for the settings you are choosing. If you wish
to go back and reconfigure your boards (using the EISA
Configuration Utility Diskette) or read the ECA documentation,
answer “n” to the next question.
Do you want to continue? (y/n)
TYPE: y
PRESS: Enter
17. The following menu appears:
ALTOS ETHERNET CHANNEL ADAPTER SETUP
1. Install the ECA driver
2. Disable th ECA driver
3. Change current ECA configuration
4. Display current ECA configuration
q. Quit
Enter Selection:
TYPE: 4
PRESS: Enter
18. The following message appears:
Current ECA driver configuration:
Total ECA boards configured: 1
Board Slot IRQ I/OAddrRange Interface
0 6 10 6c80\N6caf enc00,enc01
1 – – – disabled
Press to continue:
Verify that the displayed IRQ for Board 0 is 10 and the interface contains
“enc00”, then:
PRESS: Enter
The menu from Step 17 appears again.
TYPE: q
PRESS: Enter
19. The system prompts:
Installing ALTOS TCP/IP over aaa