Paradyne 6800 - Manual (Page 46)

Preparing the Processors
2-23 6800-A2-GN22-30 January 1997
4. Remove the memory board by unscrewing the hold-down screw on the board in memory
Slot 0 located at the bottom of the processor; gently pull the board until it is free of the slot.
Place the board on a flat surface with its memory plug facing you.
5. Each of the four memory banks on the board should already have a memory SIMM
installed in the first and second positions. Install each of the new 4 megabyte SIMMs as
follows:
a. Hold the SIMM over the SIMM socket on the memory board with the SIMM’s “key
notch” located at the bottom and facing opposite the memory plug. This is the only
way the SIMM can fit into the socket.
b. Firmly press the SIMM into the socket.
c. When the SIMM is seated properly in the socket, tilt it back with the pegs showing
through the guide holes; press firmly until it snaps into place with the plastic arms on
each side of the socket holding it securely.
CAUTION
If any difficulty is encountered in fitting the SIMM into the
socket, getting the guide pegs into the guide holes on the
SIMM, or snapping the plastic arms securely in place, you may
have the SIMM facing the wrong direction, or it may be the
wrong part.
6. Reinstall the memory board into memory Slot 0 in the processor from which it was
removed by gently pushing it back until it is firmly seated in the slot.
7. Screw the hold-down screw back into the processor.
8. Replace the processor side cover, tighten down the screws, and power on the processor
with the on/off switch.
9. When the system boots, the following messages appear:
Invalid configuration information - please run SETUP program
Select [1] to boot from Hard Disk
Select [2] to boot from Floppy
Select [3] to boot from Tape Select
[4] to enter BIOS setup
Enter option:
TYPE: 4