Full-feature workstation, Preinstallation checks for the etherlink ii card – Paradyne 6800 User Manual

Page 74

Text mode
Original mode

Preparing the Processors

2-51

6800-A2-GN22-30

January 1997

Full-Feature Workstation

Preinstallation Checks for the EtherLink II Card

The 3COM EtherLink II Card is installed at the factory for workstations from Paradyne but the
user should check that the settings on the card are properly configured.

1. Check the jumper settings on the EtherLink II card (see Figure 2-27). Confirm that:

a. The I/O Base Address jumper at J3 is set to 300.

b. The Memory Address jumper at J3 is set to C8000.

c. The Data Mode jumper at J5 is set to 16 bit transmission.

2. Be sure that the EtherLink II card is properly seated.

300
310
330
350
250
280

2A0
2E0

I/O BASE

DISABLE

C8000

CC000

D8000

DC000

MEMOR

MODE

493-14256

Figure 2-27. EtherLink II Card Jumper Settings