Paradyne 6800 - Manual (Page 192)

Loading and Restoring Software
5-31 6800-A2-GN22-30 January 1997
Add the IP addresses and names of all workstations that the host will be directly
communicating with in the format:
nnn.nnn.nnn.nnn ffw-name
Where: nnn is a number from 1 to 255 inclusive and
ffw-name is the name of the full feature workstation processor.
NOTE
For the 15000 platform, the division of full-feature workstations
among the three processors should be:
Host Uip-1 Uip-2
7 3 14
Configurations with lower numbers of full-feature workstations
should retain equivalent ratios among the processors for best
performance.
Save your changes, then exit vi.
TYPE: vi $HOME/.rhosts
PRESS: Enter
Add the names of all workstations connected to the host processor, one name to a line.
Save these changes and exit vi.
NOTE
If a full-feature workstation is to communicate with the UIP, do not
put that workstation’s IP address and processor name in the host’s
/etc/hosts or .rhosts files.
3. To change the IP address of a host already configured at the factory:
TYPE: netconfig
PRESS: Enter