Paradyne 6800 - Manual (Page 110)

COMSPHERE 6800 Series Network Management System
4-6 January 1997 6800-A2-GN22-30
Connecting the Second Full-Feature Workstation
To connect the second full-feature workstation, you will have to set up a TCP/IP Ethernet network.
Figure 4-3 shows what this network will look like with the second full-feature workstation
connected.
Ethernet
Card
494-13899a-02
Host
Processor
Network Hub Unit
035-0116-5031*
Console/
Full-Feature
Workstation
Full-Feature
Workstation
EtherLink II
Card
035-0116-5031
Cable 035-0116-5031 is 50' in length.
Other lengths available:
035-0116-2531 25'
035-0116-9031 100'
035-0116-9931 200' *
Figure 4-3. Local Area Network with Second Full-Feature Workstation
The Ethernet circuit card must be activated in the host processor (see Chapter 2, Preparing the
Processors) to support the second full-feature workstation. To complete the network installation,
you will need the following equipment:
•
A network hub unit (Figure 4-4)
•
Two modular cables (035-0116-5031)
•
AUI adapter
NOTE
ALL devices on the network must have link integrity enabled. If any
part of the network is reusing StarLAN equipment, these StarLAN
devices must have link integrity switches and you must set link
integrity to enabled. Any older StarLAN network equipment which
does not have the link integrity option switch must be replaced.