Paradyne 6800 User Manual

Page 235

COMSPHERE 6800 Series Network Management System

5-74

January 1997

6800-A2-GN22-30

20. The system prompts:

Select network configuration
1. Grafpoint’s own built-in TCP/IP
2. FTP Software’s PC/TCP
3. Sun Microsystem’s PC/NFS ver’s 3.5—3.9
4. Beame and Whiteside BW-TCP
5. Woolongong’s Pathway TCP

Enter selection of ‘q’ to Quit [1]:

PRESS: Enter

21. The system then prompts:

Select Network Interface
.
.
.
9. Packet Driver

Enter selection or ‘q’ to Quit:

TYPE: 9

PRESS: Enter

Will you be using more than one Network board in your machine
with more than one packet driver loaded (y/n/q)? [n]:

PRESS: Enter

NOTE

If you are using basic network configuration, check the IP address in
Table 5-1. Otherwise, consult with your System Administrator to
ensure entering the correct IP address.

Enter this system’s IP address:

TYPE: IP address in format “xxx.xxx.xxx.xxx” where xxx is a number from 1 to 255

inclusive

PRESS: Enter

NOTE

Consult with Network Administrator to verify correct subnet mask.

Enter a subnet mask [255.0.0.0]:

PRESS: Enter