Paradyne 6800 - Manual (Page 113)

Connecting the Components
4-9 6800-A2-GN22-30 January 1997
Connecting the Fourth, Fifth, and Sixth Full-Feature Workstations
To install a fourth, fifth, and sixth full-feature workstation, you will have to connect each
workstation to the network hub. Figure 4-6 shows what the network will look like with the
additional workstations.
To connect the fourth, fifth and/or sixth full-feature workstations, you will need one modular cable
(035-0116-5031) for each workstation. When you have this equipment, perform the following
steps:
1. Connect one end of the 035-0116-5031 cable to the jack on the EtherLink II card in a
full-feature workstation, as shown in Figure 4-6.
2. Connect the other end of the 035-0116-5031 cable to a port on the network hub unit.
3. Repeat this procedure for each of the other two full-feature workstations, if necessary.
494-13900a-02
Host
Processor
Network Hub Unit
035-0116-5031
Ethernet
Card
Console/
Full-Feature
Workstation
Full-Feature
Workstation
User Interface
Processor
035-0116-5031
EtherLink II
Card
035-0116-5031
Console/
Full-Feature
Workstation
Ethernet
Card
Figure 4-6. Local Area Network with Additional Full-Feature Workstations