Paradyne 6800 - Manual (Page 215)

COMSPHERE 6800 Series Network Management System
5-54 January 1997 6800-A2-GN22-30
14. The following system prompt appears:
Do you want this kernel to boot by default? (y/n):
TYPE: y
PRESS: Enter
to proceed.
15. When the prompt
Do you want the kernel environment rebuilt? (y/n)
appears,
TYPE: y
PRESS: Enter
A message appears indicating when the installation is complete.
To shut down and reboot the system,
TYPE: cd /
PRESS: Enter
TYPE: shutdown -g0 -y -i6
PRESS: Enter
This command will shutdown and reboot the system. Then, remove the tape and floppy
disk.
Network Configuration of NMS UIP
The NMS UIP requires information on other processors it will communicate with on the network.
This information is stored in a file, /etc/hosts, which must contain the name of each processor and
its associated IP address. While logged in as root, you must do the following:
1. If using the basic network configuration and the defaults provided:
TYPE: cp /etc/uip.basic /etc/hosts
PRESS: Enter
Go to Step 5.
2. If customizing the network configuration to connect to an existing 10BaseT network:
TYPE: vi /etc/hosts
PRESS: Enter
3. Add the IP address and NMS host processor name to the /etc/hosts file in the format:
nnn.nnn.nnn.nnn host-name
Where: nnn is a number from 1 to 255 inclusive and
host-name is the name of the NMS host processor.