Paradyne 6800 - Manual (Page 148)

COMSPHERE 6800 Series Network Management System
4-44 January 1997 6800-A2-GN22-30
Connecting Remotely
To connect a remote NetView/PC to the host processor, you will need the following materials:
•
035-0153-0031 cable
•
002-0039-0031 connector
•
Two DCE devices with the following characteristics:
— Asynchronous
— Full-duplex
— Flow control ON
— Bit rates of 1200, 2400, 4800, 9600 bps
•
835-3564-2511 cable
To establish the connection, perform the following steps at the host processor end:
1. Connect the grounded end of a 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the local DCE device.
Perform the following steps at the remote end:
1. Connect one end of the 835-3564-2511 cable to the serial port on the NetView/PC.
2. Connect the other end of the 835-3564-2511 cable to the remote DCE devices.