Paradyne 6800 - Manual (Page 37)

COMSPHERE 6800 Series Network Management System
2-14 January 1997 6800-A2-GN22-30
4. When you have installed all cards in the processor, you must run the EISA Configuration
Utility to configure the System 5000’s resources to match the requirements of this circuit
card. For instructions, refer to the section, EISA Configuration Utility.
Preinstallation Checks for the Token Ring Card
The Proteon P1990 plus Network Interface Card requires no jumper or switch settings on the card.
All settings are configured using the EISA Configuration Utility.
Optional Host Upgrade Procedures
Once you have obtained the appropriate field upgrade package and configured the cards, you are
ready to install the circuit cards in the host processor. The following sections explain how to do
this.
Installing the Third Hard Drive in the System 5000
To physically install the third hard disk drive in the System 5000 chassis (refer to Figure 2-8),
perform the following steps:
1. Attach the 3.5
I mounting brackets to the side of the disk drive.
2. Slide the drive into the chassis and attach the 50-pin SCSI bus cable using the next
connector available on the cable.
3. Attach the 5-pin power connector to the disk drive.
4. Insert the screws through the mounting bracket into the front of the chassis. Secure the
drive in the chassis.