Paradyne 6800 - Manual (Page 239)

COMSPHERE 6800 Series Network Management System
5-78 January 1997 6800-A2-GN22-30
Installing the Token Ring Software on the Full-Feature Workstation
The GrafPoint X-One server software must be installed prior to the installation of any software on
the full-feature workstation. X-One must be configured for use with a packet driver. For more
information, please refer to the section Installing GrafPoint X-One Software Package with a
StarLAN 10 NAU.
To install the NIC driver and LAN support program, perform the following steps:
1. Power up the full-feature workstation and insert the Proteon distribution floppy, labeled
p5025 ProNet – 4/16 Diag & Drvrs for P139x NIC, into the floppy drive.
TYPE: a:install a: c:
PRESS: Enter
2. The system displays the following:
The program will now make a directory on your hard disk named PROINST and
copy several files including the documentation files to that directory from the
distribution diskette. The Proteon Installation, Configuration, and Diagnostic
Program will then be run from your hard disk. DO NOT REMOVE THE PROTEON
DISTRIBUTION DISKETTE UNTIL YOU ARE ASKED TO DO SO.
Press any key to continue . . .
PRESS: Enter
3. The installation program and files are copied to the workstation’s hard disk. This process
takes several minutes. When the installation banner appears, the system prompts:
Press any key to continue . . .
PRESS: Enter
4. The installation function selection menu appears:
Select a Function
Configure/Install NIC and NetWare Drivers
Run Proteon Diagnostic Program
Install Proteon LAN Support Program
Microsoft LAN Manager Driver Installation Instructions
IBM LAN Server Driver Installation Instructions
View ReadMe File
X – eXit Install
Using the
↓↑
keys, select Install Proteon LAN Support Program and
PRESS: PRESS: Enter
5. The system prompts for temporary space; accept the default, C:PTEMP, and
PRESS: PRESS: Enter
6. The Proteon LAN Support Setup screen appears:
Proteon LAN Support Setup