Paradyne 6800 - Manual (Page 172)

Loading and Restoring Software
5-11 6800-A2-GN22-30 January 1997
The system will display several status messages followed by:
Installation and configuration of the Altos/SCO UNIX System V Operating System
is now complete. Remove the Filesystem (Volume 2) floppy and the Cartridge tape
(Volume 3) AFTER the system is shutdown, and press to restart the system.
** Safe to Power Off **
-or
** Press Any Key to Reboot **
CAUTION
Do not remove the boot floppy or tape until the Press Any Key
to Reboot prompt is displayed.
11. Remove both the floppy disk and the cartridge tape.
PRESS: any key
to reboot the system. The system auto-boots; on a System 5000, do not press the spacebar
to interrupt auto-boot. The following prompt appears:
Boot
:
PRESS: Enter
INIT: SINGLE USER MODE
Type CONTROL-d to proceed with normal startup,
(or give root password for system maintenance):
NOTE
You have approximately 10 seconds to type the root password and press the
Enter key to select system maintenance. Failure to do so within the
10-second window will load to normal start-up. If this occurs, a reboot is
necessary.
12. To go into the system maintenance mode:
TYPE: root password
PRESS: Enter
13. Insert the 6800 NMS Application Volume 4 floppy disk and 6800 NMS Application
Volume 5 cartridge tape.
14. At the # prompt,
TYPE: installpkg
PRESS: Enter