Paradyne 6800 - Manual (Page 174)

Loading and Restoring Software
5-13 6800-A2-GN22-30 January 1997
Available options:
1. Add a chain
2. Remove a chain
3. Reconfigure an element in a chain
q. Quit
Select option:
TYPE: 1
PRESS: Enter
The system displays the top-level chain descriptions and prompt:
Select top level of chain to Add or q to quit:
TYPE: 1 (for altos\Mtcp)
PRESS: Enter
The system prompts:
Select next level of chain to Add or q to quit:
TYPE: n
PRESS: Enter
Where: n is 5 on Altos 5000 platform 6 on Altos 15000 platform
The system prompts for confirmation:
Add chain altos_tcp -> aaa (y/n):
TYPE: y
PRESS: Enter
Where: aaa is en0 on Altos 5000 platform
enc00 on Altos 15000 platform
The following messages appear:
Adding altos_tcp -> aaa
Enable aaa driver
If you are installing an Altos 5000 host, go to Step 19. Otherwise, the following messages
appear:
ALTOS ETHERNET CHANNEL ADAPTER SETUP
This utility is used to setup the ECA board device driver. You may
install or display the driver configuration. To install the ECA
driver or change the driver configuration, there are several
parameters that you must supply. These are listed as follows:
a. The number of ECA boards installed in the system
b. The EISA slot number of each ECA board
c. The Interrupt Number (IRQ), shared among all ECA boards