Paradyne 6800 - Manual (Page 166)

Loading and Restoring Software
5-5 6800-A2-GN22-30 January 1997
Customized Network Configuration
Where the NMS will be installed at a site with an existing local area network, the Network
Administrator there may require that the NMS node names and IP addresses follow the standards
of that site. This custom installation is also required for the Altos 15000. If the NMS has not been
factory installed, the node names and IP addresses can be set during the normal NMS installation
procedures. For processors where the NMS software has been factory installed, the host and UIP
processors can be modified using netconfig, a program designed for just this purpose. On
full-feature workstations the GrafPoint X-One software must be reinstalled following the
instructions in this chapter and setting the IP address at the proper point in the installation process.
For the 15000 platform, the IP address and node names must be entered via one custom method. If
one existing local area network is not a constraint, the values in Table 5-2 should be entered.
Table 5-2
Altos 15000 Basic Network Configuration Parameters
Processer IP Address Node Name
6800 NMS host processor 1.1.1.1 unix
6800 UIP 1 1.1.1.2 uip-1
6800 UIP 2 1.1.1.3 uip-2
1st full-feature workstation 1.1.1.4 ws1
2nd full-feature workstation 1.1.1.5 ws2
.
.
. .
.
. .
.
.
24th full-feature workstation 1.1.1.27 ws24