Paradyne 6800 - Manual (Page 180)

Loading and Restoring Software
5-19 6800-A2-GN22-30 January 1997
The system prompts:
INIT: Single User Mode
Type CONTROL-d to proceed with normal startup,
(or give root passwrd for system maintenance)
PRESS: Cntl-d
When the login prompt appears, the procedure on the Altos 5000 is complete.
b. For an Altos 15000 system, enter the following command to reboot in single user
mode:
TYPE: shutdown -g0 -y -i1
PRESS: Enter
The system prompts:
INIT: New run level: S
INIT: Single User Mode
Type CONTROL-d to proceed with normal startup,
(or give root passwrd for system maintenance)
PRESS: Cntl-d
When the login prompt appears, the procedure on the Altos 15000 is complete.
Installing the MPX Software on the Altos 15000
This section describes how to install the Altos MPX Multiprocessing software on the Altos System
15000 host processor. Skip this section if you are installing on an Altos 5000.
To install the MPX software, perform the following steps:
1. At the system prompt,
TYPE: cd /usr/MPX
PRESS: Enter
TYPE: ./installMPX
PRESS: Enter
2. Use the
↓↑
keys to highlight Install and
PRESS: Enter
3. Use the
↓↑
keys to highlight A New Product and
PRESS: Enter
4. The system prompts you whether to install all or part of the software. Use the
↓↑
keys to
highlight Entire Product and
PRESS: Enter