Paradyne 6800 - Manual (Page 252)

Loading and Restoring Software
5-91 6800-A2-GN22-30 January 1997
3. After the searches are complete, the system displays the message:
Confirm
The current system configuration will support only 1
IPC-900 board. If installation
continues, 1 board will be configured.
Strike ENTER when ready
or ESC to stop.
To continue,
PRESS: Enter
4. The system prompts for the values to configure the IPC-900 card:
Please enter the following system configuration information
for IPC-900 board;
The available interrupt(s) for the IPC-900 Board are:
IRQ 2
IRQ 3 (default)
IRQ 5
IRQ 10
IRQ 15
Type the interrupt number and strike the ENTER key or type
Q to cancel installation. Striking ENTER alone will
select the default.
For the IRQ,
TYPE: 5
PRESS: Enter
NOTE
The list of available IRQs as well as the I/O addresses and memory
addresses is determined dynamically. Depending on the boards
installed in the host, the IRQ, I/O and memory, output may vary.
However, the installer should always enter the values listed in this
install script.
5. The system prompts for the value of the starting I/O address:
Please enter the following system configuration information
for the IPC-900 board:
The available starting I/O address for the IPC-900 Board are:
Starting I/O address: 2A0
Starting I/O address: 2B0
.
.
.
Starting I/O address: 3E0