Paradyne 6800 - Manual (Page 183)

COMSPHERE 6800 Series Network Management System
5-22 January 1997 6800-A2-GN22-30
3. Set the proper time zone by entering the command
/etc/tz
The system asks:
Are you in North America? (y/n)
TYPE: y (as appropriate)
PRESS: Enter
The system displays a list of time zones for the specified continent and prompt:
Enter the number that represents your time zone or enter q to quit:
TYPE: the number of the appropriate time zone
PRESS: Enter
The system asks:
Does daylight saving time (summer time) apply at your location? (y/n)
TYPE: y or n (as appropriate to your location)
PRESS: Enter
4. You are now ready to execute the installpkg command and begin the installation process.
To do this,
TYPE: installpkg
PRESS: Enter
The installation program prompts you to insert a floppy disk into the disk drive and press
Enter.
5. Insert the disk labeled 6800 NMS Application Volume 6 into the floppy drive and the tape
labeled 6800 NMS Application Volume 7 into the tape drive.
PRESS: Enter
A series of status messages appears showing that the installation program is reading and
processing the contents of the floppy disk.
6. The following message appears:
Installing NMS Release 4.2.
7. At this point, the installation program will check for the existence of a previous release of
the NMS.
If a previous release of NMS is found, the system prompts regarding how to remove it. If
an active workstation is found, the system prompts regarding how to remove it.