Paradyne 6800 - Manual (Page 241)

COMSPHERE 6800 Series Network Management System
5-80 January 1997 6800-A2-GN22-30
10. Instructions for selection of values for the Proteon board then appear.
If you are using a p189x or p199x board, you must configure the board using the
system’s reference disk.
If you are using a p139x board, command line options are used to configure the
iobase, interrupt vector, etc.
This utility will help you by editing these command line options into the config.sys file
for you.
Press ENTER to continue; ESCAPE to go back to previous selections.
To continue,
PRESS: Enter
11. The selection menu for board type appears:
Select the type of board you are using.
p139x – p1390,p1391, or p1392
p189x – p1890 or p1892
p199x – p1990
Using the
↓↑
keys, select p139x – p1390,p1391, or p1392 and
PRESS: Enter
12. The system prompts for the Interrupt Vector with a default of 5.
PRESS: Enter
13. The system prompts for the DMA Channel with a default of 5.
PRESS: Enter
14. The system prompts for the Base I/O Address with a default of 0A20.
PRESS: Enter
15. The system prompt for transmission speed. Use the
↓↑
keys to select either 4 Mbps or
16 Mbps, depending on the speed of any existing Token Ring network or the site standard,
and
PRESS: Enter
16. The system prompts for the type of cable you are using. Use the
↓↑
keys to select either
UTP for unshielded twisted pair or STP for shielded twisted-pair, depending on whether
you have installed the RJ45 cable or the Token Ring coaxial cable, and
PRESS: Enter
17. A confirmation window appears for the preceding selected values and the system prompts:
Satisfied with your selections?
Press ENTER to continue; ESCAPE to change selections