Paradyne 6800 - Manual (Page 142)

COMSPHERE 6800 Series Network Management System
4-38 January 1997 6800-A2-GN22-30
Perform the following steps at the remote end:
1. Connect the grounded end of the 035-0152-0031 cable to one of the user ports on the
System Controller or ACCULINK Network Manager.
2. Connect the other end of the 035-0152-0031 cable to the 002-0050-0031 connector.
3. Connect the 002-0050-0031 connector to the DCE device.
See Appendix A, Modem Settings, for more information on optioning 3810, 3811, 3820, or
2224CEO modems for this application.
Connecting a Local Dial Backup Control Unit
To connect a local 839A DBU, you will need the following materials:
•
035-0153-0031 cable
•
002-0039-0031 connector
To establish the connection, perform the following steps:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor or the UIP.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the terminal port of the 839A DBU Control Unit.
Connecting a Remote Dial Backup Control Unit
To connect a remote 839A DBU, you will need the following materials:
•
035-0153-0031 cable
•
002-0039-0031 connector
•
Two DCE devices with the following characteristics:
— Asynchronous
— Full-duplex
— Flow control ON
— Bit rates of 1200, 2400, 4800, and 9600 bps
•
035-0151-0031 cable
To connect a remote DBU, perform the following steps at the processor end:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor or the UIP.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the local DCE devices.