Paradyne 6800 - Manual (Page 50)

Preparing the Processors
2-27 6800-A2-GN22-30 January 1997
Preinstallation Checks for the Token Ring Card
The Proteon P1990 plus Network Interface Card requires no jumper or switch settings on the card.
All settings are configured using the EISA Configuration Utility.
Optional UIP Upgrade Procedures
Once you have obtained the desired field upgrade package and prepared it for installation, you can
then install the circuit card(s) in the UIP. The procedures for installing circuit cards in the UIP are
the same as those for installing in the Altos System 5000 host processor. Refer to the sections,
Installing Circuit Cards in the System 5000 and Closing the System 5000.
Converting Altos 5000 Processors to Release 4.2 UIPs
Altos 5000 processors from previous releases of NMS can be converted to UIPs for Release 4.2
NMS. The steps taken depend on what use the System 5000 had under the previous NMS and how
it will be used with Release 4.2. Table 2-4 describes the major actions to be taken when converting
a “Source” system to a 4.2 UIP.
Table 2-4
Altos 5000 UIP Conversion Matrix
Target System
Source System
4.2 UIP Connected To
Altos 5000 Host
4.2 UIP Connected To
Altos 15000 Host
R3.1 Altos 5000 host with
32 Mb and StarLan N/A Add 16 Megabytes memory
Remove StarLan card and check
Integral Ethernet card
R3.1 Altos 5000 UIP with
16 Mb and StarLan Add 16 Megabytes memory
Remove StarLan card and check
Integral Ethernet card
Add 32 Megabytes memory
Remove StarLan card and check
Integral Ethernet card
R4.1 Altos 5000 host with
32 Mb and Ethernet N/A Add 16 Megabytes memory
R4.1 Altos 5000 UIP with
32 Mb and Ethernet No changes required. Add 16 Megabytes memory