Paradyne 6800 User Manual

Page 78

Preparing the Processors

2-55

6800-A2-GN22-30

January 1997

NOTE

Before optioning the NAU, check the faceplate to determine if this
version of the NAU has a Link Integrity Function Switch. If it does,
move the switch to the enabled position. If the StarLAN NAU does
not have a Link Integrity Function Switch, you

must replace the NAU

with an EtherLink II card. For more information, refer to the

StarLAN

10 Network PC NAU Installation Guide.

Figure 2-29 shows the jumper locations and settings for the NAU. To implement the setting and
install the StarLAN 10 PC NAU, perform the following steps:

1. Use the default IRQ setting of 2 (J12).

2. Use the default I/O address setting of 360—367 (J3).

3. Set the RAM address to C8000—C8FFF, Pins 2 & 3 (J6).

4. Set the RAM size to 16 kb (J5).

5. Insert the card into Slot 3.

6. Insert the appropriately configured StarLAN 10 NAU into Slot 3 and secure with the

chassis screw.

7. Insert the Paradise Windows Accelerator video card in the first available slot and secure

with a chassis screw. Confirm that all SW1 switches are in the OFF position.

8. Close the 6386/25 computer cover and reconnect monitor and keyboard cables.

9. Insert the Customer Test disk that comes with the 6386/25. This disk will be used to

reformat the hard disk.

10. Start the 6386/25 and the computer will boot from the Customer Test disk. The Customer

Diagnostics introduction screen is displayed.

PRESS: Enter

J14

SPARES

J13

J11

J12

491-11704a

Figure 2-29. NAU Memory Jumper Locations and Settings