Paradyne 6800 - Manual (Page 157)

Connecting the Components
4-53 6800-A2-GN22-30 January 1997
Connecting the ANALYSIS 6510/5605
To connect a remote ANALYSIS 6510/5605 to the host processor, perform the following steps at
the remote end:
1. Connect one end of the 835-5783-0011 cable to Port 1 on the ANALYSIS 6510/5605.
2. Connect the other end of the 835-5783-0011 cable to the DCE device.
Perform the following steps at the host computer end:
1. Connect the gronded end of the 035-0153-0031 cable to a port on the IPC-900 card
dedicated for ANALYSIS use.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the DCE device.
Connecting the ANALYSIS 5600
To connect a remote ANALYSIS 5600 to the host processor, perform the following steps at the
remote end:
1. Connect the 002-0019-0031 connector to Port 1 on the ANALYSIS 5600.
2. Connect the end of the 835-4613-2511 cable marked Terminal to the 002-0019-0031
connector.
3. Connect the end of the 835-4613-2511 cable marked Controller to the DCE device.
Perform the following steps at the host processor end:
1. Connect the grounded end of the 035-0153-0031 cable to a port on the IPC-900 card.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to the DCE device.