Paradyne 6800 - Manual (Page 222)

Loading and Restoring Software
5-61 6800-A2-GN22-30 January 1997
2. The Welcome screen appears.
PRESS: Enter
3. The screen displays the default settings for Date/Time, Country, Keyboard and Install to
Hard Disk. Change the defaults, if necessary.
PRESS: Enter
4. The screen displays two setup options (Install to C:\DOS and Run Shell on start up – Yes).
Change the second option so that the shell will not run at start-up. Follow the instructions
displayed on the screen.
PRESS: Enter
5. A new screen displays a graph indicating the percentage of information transferred from
the floppy disk to the hard disk.
When prompted remove Disk 1 and insert Disk 2.
PRESS: Enter
6. When prompted, remove Disk 2 and insert Disk 3.
PRESS: Enter
7. When prompted, remove Disk 3.
PRESS: Enter
The system reboots; MS-DOS 5.0 is installed and running.
Installing the GrafPoint X-One Software Package with EtherLink II Card
To install the GrafPoint X-One Server program and associated software, perform the following
steps:
1. Insert the GrafPoint X-One Installation disk into the drive and
TYPE: A:install
PRESS: Enter
2. The system prompts:
Enter the floppy drive to use [A:]:
PRESS: Enter
3. The system prompts:
Enter the destination drive to use [C:]:
PRESS: Enter
4. The system prompts:
Enter the destination directory to use [\/XONE]:
PRESS: Enter