Paradyne 6800 User Manual

Page 257

COMSPHERE 6800 Series Network Management System

5-96

January 1997

6800-A2-GN22-30

NOTE

The total number of local terminals configured determines the
number of 6800 Series NMS cut-through sessions to an individual
ANALYSIS NMS. The following rules apply:

NUMBER OF LOCAL TERMINALS NUMBER OF CUT-THROUGHS ALLOWED

2 — 6

6 — number of local terminals

On the ANALYSIS side, you will be asked as a part of the

syssetup

procedure to enter the number of permitted cut-throughs. It is
important that you enter the same number during that procedure as
is calculated in this step.

For example, assume you have two local terminals attached to your
ANALYSIS NMS. Enter 2 in this step and the

config6510 program will

determine that four cut-through sessions are permitted (6 minus 2 =
4). On the ANALYSIS NMS side, you should enter 4 when prompted
by the syssetup program for the number of cut-through sessions.
(For additional information, refer to the

ANALYSIS 6510 Automated

Network Management System Reference Manual).

5. The system prompts you to confirm the information entered in the previous steps.

Is the information correct [y or n, q to quit]?

TYPE: y (if the displayed information is correct)

PRESS: Enter

6. The database is updated and your selection is confirmed with the following message:

Please wait... “system name” added to system

where system name is the name entered in Step 2.

7. To exit the configuration process,

TYPE: 4

PRESS: Enter

8. To add more 6510 configurations, return to Step 1.