Paradyne 6800 - Manual (Page 186)

Loading and Restoring Software
5-25 6800-A2-GN22-30 January 1997
The system prompts for confirmation.
TYPE: y
PRESS: Enter
NOTE
If you plan to use the default network configuration on an Altos 5000
System, you
must enter uip-1 as the uip name.
A series of additional messages appears indicating that the kernel files are being updated,
the configuration file created, and the full-feature workstation installed.
The following message appears:
Do you wish to have the screen-saver capability (y/n) [n]
TYPE: y (for an automatic time-out of the CRT)
PRESS: Enter
or
TYPE: n (for a continuous display)
PRESS: Enter
The installation program displays a message indicating that the post-installation phase of
the installation is complete.
14. At this point, the operating system is rebuilt. When this is complete, you will be asked
whether you want the kernel to boot by default. To indicate yes,
TYPE: y
PRESS: Enter
A second prompt appears, asking whether you want the kernel environment rebuilt.
TYPE: y
PRESS: Enter
A message appears indicating the installation is complete. If you installed the 5000 System,
proceed to Step a. If you installed the 15000 System, proceed to Step b.
a. For the 5000 system, you must shutdown and reboot the system to activate the kernel.
To do this, remove the floppy disk and cartridge tape, and
TYPE: cd /
PRESS: Enter
TYPE: shutdown -g0 -y -i6
PRESS: Enter
The system will reboot.