Paradyne 6800 - Manual (Page 202)

Loading and Restoring Software
5-41 6800-A2-GN22-30 January 1997
Unix Software for the UIP
To install the UNIX Operating System on the UIP’s hard disk, you need the following software:
•
A floppy disk labeled 6800 UIP Application Volume 1
•
A floppy disk labeled 6800 UIP Application Volume 2
•
A cartridge tape labeled 6800 UIP Application Volume 3
•
A floppy disk labeled 6800 UIP Application Volume 4
•
A cartridge tape labeled 6800 UIP Application Volume 5
With these items, perform the following steps:
1. Turn on the UIP and make sure the RESET key is in the RUN position. The UIP begins the
boot process and runs through its internal memory checks. When the memory check is
over, the following message appears:
Press space bar to interrupt autoboot
NOTE
If an error message about memory appears, ignore it and continue
the procedure.
PRESS: the spacebar immediately
The menu in Figure 5-6 appears:
492-13954
Select [1] to boot from Hard Disk
Select [2] to boot from Floppy
Select [3] to boot from Tape
Select [4] to enter BIOS setup
Enter Option:
Figure 5-6. System 5000 Boot Menu (Installing UNIX on UIP)
NOTE
If this menu does not appear you missed the time-out window. You
must restart the procedure.