Paradyne 6800 - Manual (Page 208)

Loading and Restoring Software
5-47 6800-A2-GN22-30 January 1997
The following messages appear:
Adding altos_tcp -> en0
Enable en0 driver
Installing ALTOS TCP/IP over en0
Please enter the following information in order to configure en0
The system prompts:
Enter the internet address of this interface
TYPE: internet address
in the form nnn.nnn.nnn.nnn
Where: nnn is an integer from 1 to 255
PRESS: Enter
The system prompts:
Enter the netmask for this interface (default: 255.255.0.0):
NOTE
Consult your System Administrator to determine whether to specify
a net mask, a broadcast address, or DOMAIN name different from
the default. Choose the default when using the basic network
configuration as described in the
Network Pre-Installation
Preparation section.
PRESS: Enter
The system prompts:
Does the interface use a broadcast address of all 1’s? (y/n) (default:y):
PRESS: Enter
The system prompts:
Enter the broadcast address for this interface (default: nnn.nnn.255.255):
NOTE
The displayed default shows the first two levels of the IP address
you have just entered. The default above for broadcast address
assumes the use of the basic network configuration parameters.
PRESS: Enter
The system asks for verification of the previously entered values:
Interface Address:
Netmask:
Broadcast Address: