Paradyne 6800 - Manual (Page 258)

Loading and Restoring Software
5-97 6800-A2-GN22-30 January 1997
9. After the requested ANALYSIS controller(s) is added, the system displays the following
message:
Do you wish to see a system summary? ( y or n)...
If you respond with y (yes), the system displays a list in the following format:
System Name CC Name Port # # Cut-Throughs
“name” a1 “value” “value”
“name2” a2 “value2” “value”
Please note! For the changes you have made to take effect, the NMS system must be
shut down and then restarted.
10. Program execution is completed and the system displays the UNIX prompt. You must shut
down the NMS system and reboot the host computer. See Chapter 6 for detailed
instructions on how to reset the host computer.
Changing 6510 Parameters
The following procedure provides information on changing the parameters for an existing 6510.
1. The ANALYSIS Selection menu (Figure 5-10) is displayed on your screen. The letter n
represents the number of ANALYSIS 6510’s already configured.
492-13958-01
Maximum ANALYSIS 6510s supported = 6
n Analysis 6510(s) already installed
Do you wish to:
1. Add a 6510 to the system
2. Remove a 6510 from the system
3. Change a 6510's parameters
4. Exit program
Enter a number from 1-4...
Figure 5-10. ANALYSIS Selection Menu (for Changing 6510 Parameters)
To change the parameters for an existing 6510,
TYPE: 3
PRESS: Enter