Paradyne 6800 - Manual (Page 231)

COMSPHERE 6800 Series Network Management System
5-70 January 1997 6800-A2-GN22-30
Installing GrafPoint X-One Software Package with a StarLAN 10 NAU
To install the GrafPoint X-One Server when a StarLAN NAU card will be used, perform the
following steps:
1. Insert the GrafPoint X-One Installation disk into the drive and
TYPE: A:install
PRESS: Enter
2. The system prompts:
Enter the floppy drive to use [A:]:
PRESS: Enter
3. The system prompts:
Enter the destination drive to use [C:]:
PRESS: Enter
4. The system prompts:
Enter the destination directory to use [\/XONE]:
PRESS: Enter
If the directory, \XONE, does not exist, the system prompts:
The directory C:\XONE does not exist. OK to create it? (y/n) [y]
PRESS: Enter
5. The system asks a series of questions to which you should reply as follows:
Do you wish to install the fonts (y/n)? [n]:
TYPE: y
PRESS: Enter
The system prompts:
Do you wish to install the standard set of fonts,
including ‘MISC’ and ‘75DPI’ (y/n): [y]
PRESS: Enter
Do you wish to install the 100DPI fonts (y/n)? [n]
TYPE: y
PRESS: Enter
Do you wish to install the OpenWindows fonts: (y/n)? [n]
TYPE: y
PRESS: Enter