Paradyne 6800 - Manual (Page 242)

Loading and Restoring Software
5-81 6800-A2-GN22-30 January 1997
If they are not correct, press Esc; the system requests entry again, starting with Step 12. If
the values entered are correct,
PRESS: Enter
18. The system displays statements for the CONFIG.SYS file. The statements appear as
follows:
device=C:\PROTEON\proarb.sys
device=C:\PROTEON\pro16eul.sys /B 0a20 /I 5 /D 5 /S nn
The above file C:\PROTEON\CONFIG.LSP has been created for your convenience
and future reference. It contains the necessary config.sys statements to run the LSP
software.
Press ENTER to continue; ESCAPE to change previous selections
Where: nn is the selected transmission speed, 4 Mbps or 16 Mbps
To accept them,
PRESS: Enter
19. The system prompts:
Select action of LSP statements
Add to your config.sys
No action
Replace your config.sys
Use the
↓↑
keys to select Add to your config.sys and
PRESS: Enter
20. The system displays the following confirmation.
LSP Software Setup Completed
Press ENTER to continue . . .
PRESS: Enter
21. The Installation Function Selection Menu appears as in Step 4. To exit the install
procedure,
TYPE: x
22. The system prompts:
Are you sure you want to exit the Installation Program?
TYPE: y
The DOS prompt appears.
23. Insert the floppy disk labeled “Token Ring FFW Application” in the floppy disk drive and
TYPE: a:install
PRESS: Enter
24. The following installation instructions appear on the screen.