Paradyne 6800 - Manual (Page 66)

Preparing the Processors
2-43 6800-A2-GN22-30 January 1997
4. Slide the circuit card in the guides so that its connector fits into the EISA connector.
5. Press firmly but carefully to engage the connector pins.
6. Repeat this procedure for each circuit card you intend to install.
7. When you have installed all circuit cards, secure the card’s metal bracket to the chassis
with the screw saved from Step 3.
Closing the System 15000
When all the necessary hardware and circuit cards are installed in the Altos System 15000, the
EISA Configuration Utility (ECU) must be run to configure the internal resources of the processor
to match the circuit cards physically installed. Before running the ECU, you must close the System
15000 and attach the power cable, monitor, mouse, and keyboard. To close the System 15000,
perform the following steps:
1. Replace the front cover ensuring that the top and side clips are properly engaged.
2. Re-connect the door spring to the pin at the bottom of the door hinge.
3. Reattach the two Phillips-head screws inside the door hinge.
4. Replace the left side cover.
5. Hook the right side cover rear edge around the end of the chassis with the cover at about a
30-degree angle out from the chassis.
6. Swing the right side cover inward towards the chassis and slide it down until the bottom
edge locks in place.
7. Place the top cover on the chassis, making sure that the locking pins on the cover underside
are positioned in the locking slots. Slide the cover towards the front of the chassis until the
locking pins (see Figure 2-23) engage.
NOTE
The Altos System 15000 will not power on unless the top cover is
fully engaged.