Paradyne 6800 - Manual (Page 204)

Loading and Restoring Software
5-43 6800-A2-GN22-30 January 1997
The menu in Figure 5-8 appears:
492-13956
Please specify Hardware Configuration:
1. Hardware configuration I (Single hard disk - UIP)
2. Hardware configuration II (Two hard disks - NMS HOST)
3. Exit Installation
Please enter your choice [1-3]:
Figure 5-8. Hardware Configuration Menu (Installing UNIX on UIP)
6. For the UIP,
TYPE: 1
PRESS: Enter
In response, the system sets the operating system environment, configures the hard disk,
creates a UNIX partition, and divides the partition into file systems and swap space. When
this is complete, the following message appears:
Altos UNIX System V Operating System Serialization
When prompted, use the serial number and activation key included with the
Altos System V Operating System distribution
Enter your serial number or enter q to quit
TYPE: the UNIX serial number (found on the Serial Number card attached to the Release
Notes)
PRESS: Enter
7. The following message appears:
Enter your activation key or enter q to quit
TYPE: the UNIX activation key (found on the Serial Number card attached to the
Release Notes)
PRESS: Enter
NOTE
If either the serial number or activation key is entered incorrectly, the
system prompts you again for the information. If you quit at either of
these steps, you must start the installation process from the
beginning.