Paradyne 6800 - Manual (Page 263)

COMSPHERE 6800 Series Network Management System
6-2 January 1997 6800-A2-GN22-30
Starting UNIX on the Host
To start the UNIX operating system, perform the following steps:
1. With the RESET key in the RUN position, turn on the power switch on the host
processor. The UNIX system will proceed to boot, and as it boots it will display a series
of self-check and diagnostic messages on the console screen. After these messages have
displayed, the following message will appear:
Type CONTROL-d to proceed with normal start-up,
(or give root password for system maintenance):
2. To select normal start-up, press the Ctrl and d keys simultaneously.
3. The boot process will continue. When the system has fully booted, the login prompt will
appear on your screen.
Starting the NMS Application Program
Once UNIX has been started, you can start the NMS application program. To do so, perform the
following steps:
1. At the login: prompt,
TYPE: nms
PRESS: Enter
2. In response, the Password: prompt will appear.
TYPE: the NMS password (the default password is startmenu)
PRESS: Enter
The Network Management System Menu is displayed, as shown in Figure 6-1.
491-13839
Network Management System
Select:
1) Start the system
2) Stop the system
3) System status
4) Backup system database
5) Restore system database
6) Enable/Disable auto start
7) Change password
8) Download modem firmware file
9) Shutdown UNIX
10) Install PTF
11) Return to Console login
Enter Number [1,2,3,4,5,6,7,8,9,10,11]:
Figure 6-1. Network Management System Menu