Paradyne 6800 - Manual (Page 144)

COMSPHERE 6800 Series Network Management System
4-40 January 1997 6800-A2-GN22-30
•
25-position null modem connector
•
035-0152-0031 cable
To establish the connection, perform the following steps at the processor end:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor or UIP.
2. Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.
3. Connect the 002-0039-0031 connector to one of the local DCE devices.
Perform the following steps at the remote end:
1. Connect the grounded end of the 035-0152-0031 cable to the TERM IN port on the SRCU.
2. Connect the other end of the 035-0152-0031 cable to the 002-0032-0031 connector.
3. Connect the 002-0032-0031 to the null modem connector.
4. Connect the null modem connector to the remote DCE device.
See Appendix A, Modem Settings, for further information on optioning 3810, 3811, 3820, or
2224CEO modems for this application.
Connecting a Local DCX Multiplexer
To connect a local 840/850 DCX multiplexer, you will need the following materials:
•
035-0153-0031 cable
•
002-0040-0031 connector
To establish the connection, perform the following steps:
1. Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600
card in the host processor or UIP.
2. Connect the other end of the 035-0153-0031 cable to the 002-0040-0031 connector.
3. Connect the 002-0040-0031 connector to the MIU attached to the DCX multiplexer.
Connecting a Remote DCX Multiplexer
To connect a remote DCX multiplexer, you will need the following materials:
•
035-0153-0031 cable
•
002-0039-0031 connector