Paradyne 6800 User Manual
Page 72
Preparing the Processors
2-49
6800-A2-GN22-30
January 1997
The following messages appear.
Current configuration information will be lost
if you continue.
Select
to return to previous screen
7. Select
→
/
←
keys and
PRESS: Enter
A list of configuration files appears. Refer to Table 2-8 for possible file names and
applicable configurations.
8. Use the
↓↑
keys to select the proper configuration file and
PRESS: Enter
The following messages appear.
Loading configuration files
Please wait . . .
The maximal configuration of circuit card descriptions and settings will be automatically
loaded. Use the
↓↑
keys to review the cards in the loaded configuration. Delete any cards
that you do not have installed on the system. To delete a card configuration, highlight the
card description on the screen using the
↓↑
keys and press the Delete key.
9. To verify that all resources have been correctly configured:
PRESS: Alt + v (for “view”)
PRESS: r (for “Resources”)
to display the Resource Map. This display lists the settings for each component of the
system. Use the
↓↑
keys to scroll through the Resource Map and verify that all appropriate
settings are correct. Refer to Table 2-1 for Altos 5000 host, Table 2-3 for Altos 5000 UIP,
and Table 2-5 for Altos 15000 host.
If the settings are correct,
PRESS: Enter
PRESS: Alt +s (for “System”)
PRESS: x (for “exit”)
to exit. Select Save configuration and exit by pressing the s key when prompted. Reboot
the system to allow the new settings to take effect. Remove the EISA Configuration Disk
from the floppy drive and store it safely.
NOTE
At any time in running the ECU, you may reload the configuration
file, which contains the correct settings and begin again the process
of deleting those circuit card descriptions which are not installed. To
do this, press Alt + s (for “System”) and go to Step 6.