Paradyne 6800 - Manual (Page 138)

COMSPHERE 6800 Series Network Management System
4-34 January 1997 6800-A2-GN22-30
To connect a 719 NETWORKER to the host processor, perform the following steps:
1. Connect the 035-0153-0031 cable to the IPC-1600 port that is configured as the external
systems port.
2. Connect the 002-0021-0031 connector to the 035-0153-0031 cable.
3. Connect the 002-0021-0031 connector to any unused data channel port on the
719 NETWORKER.
Connecting an Event or Command Port
To connect an event port or command port on the 719 NETWORKER to the host processor, you
will need the following materials:
•
Two 035-0153-0031 cables
•
Two 002-0021-0031 connectors
To establish the connection perform the following steps:
1. Connect 035-0153-0031 to the IPC-1600 port that is configured as the event or command
port.
2. Connect 002-0021-0031 to 035-0153-0031.
3. Connect the 002-0021-0031 to an unused data channel port on the 719 NETWORKER.
Connecting the Earlier Version 719 NETWORKER
To connect the pre-3.K version of the 719 NETWORKER, the following materials are required.
•
Two 035-0153-0031 cables
•
002-0039-0031 connector
•
002-0021-0031 connector
To connect the 719 NETWORKER to the host processor, perform the following steps.
1. Connect one end of the 035-0153-0031 cable to the IPC-1600 port that is configured as the
event port.
2. Connect the other end of the 035-0153-0031 cable to the 002-0021-0031 connector.
3. Connect the 002-0021-0031 connector to any unused data channel port on the 719
NETWORKER.
4. Connect one end of the other 035-0153-0031 cable to the IPC-1600 port that is configured
as the external systems port.
5. Connect the other end of the 035-0153-0031 cable to a 002-0039-0031 connector.
6. Connect the 002-0039-0031 connector to an unused data channel port on the 719
NETWORKER.