Paradyne 6800 - Manual (Page 182)

Loading and Restoring Software
5-21 6800-A2-GN22-30 January 1997
The system confirms the following:
Altos/SCO Multi-Processor Extensions (MPX) has been loaded.
You must reboot the system before MPX will be active. Once you have
rebooted, you can verify that multiple processors are working by logging
in as root and typing “uname-X”, and looking for the “NumCPU” field. It
should say, “NumCPU=2”. This means the system is using 2 CPUs.
Please type “init 6” to reboot the system.
13. When the UNIX prompt, #, appears:
TYPE: init 6
PRESS: Enter
The system automatically reboots.
Release 4.2 NMS Software
This section explains how to install the Release 4.2 Network Management System (NMS)
application program on an Altos System 5000 or Altos System 15000 computer.
You must install the software in multi-user mode.
To install the 6800 NMS Application Software on the host processor’s hard disk, you need the
following:
•
A floppy disk labeled 6800 NMS Application Volume 6
•
A cartridge tape labeled 6800 NMS Application Volume 7
Installing the NMS Software
To install the NMS Software, perform the following steps:
1. At the unix login,
TYPE: root (enter password, if any)
NOTE
The system cannot be installed from any other user login.
2. Set the system date and time by entering the command
date MMDDhhmmyy
where MM is the month, DD the day, hh the hour (24-hour system), mm the minute, and
yy the last two digits of the year (this is optional).